2011

Table Of Contents
Select the wire layer GREEN_10. Click OK.
TIP Make sure that Snap is turned off and that the Wire Layer is set to
GREEN_10.
Select the bottom connection point on the pump
Specify wire end or [V=start Vertical/H =start
Horizontal/Continue):
Drag the pipe down and to the right, click the connection point at the bottom
of the pressure relief valve, right-click
Completing the Hydraulic Drawing
The rest of the hydraulic drawing consists of inserting a Pressure Gauge and
Check Valve at the left side of the pump and then inserting devices (Cylinder;
Restrictors; Filter; Check valve and 2-ways valve) along the top of the drawing.
NOTE During insertion, clear the Vertical option in the Insert Component: Hydraulic
Symbols dialog box.
Insert components
1 Click Schematic tab Insert Components panel
Insert
Hydraulic Components.
Completing the Hydraulic Drawing | 1905