2011

6 Click OK.
7 Respond to the prompts as follows:
Window select starting wire connection points
Select pins 5-7 on Black Box 1 (1) and right-click
to (T= wiretype):
Drag the wires to the right past the three wires you inserted,
to Point (Continue/Flip):
Drag up the wires towards PJ2 on Black Box 2, enter C and press ENTER (to
continue and lock the drag)
to (Continue/Flip):
Drag the wires to the right and connect to pins B-D on PJ2 (2)
8 Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Multiple Bus.
9 On the Multiple Wire Bus dialog box, click OK to use the previous settings.
10 Respond to the prompts as follows:
Window select starting wire connection points:
Select pins 9-11 on Black Box 1 and right-click
Wiring connectors | 1881