2011

Delete a wire number
1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Delete Wire
Numbers.
2 Respond the prompts as follows:
Select objects: Enter all, press ENTER
The wires in the network change to dashed lines, representing the wires
from which the wire numbers will be erased.
3 Press ENTER again to erase the wire numbers.
Source signal arrows
AutoCAD Electrical uses a named source/destination concept. You identify a
wire network to be the source, insert a source arrow on that network, and
assigning a source code name to it. On the wire network that is to be a
continuation of the same wire number (whether on the same drawing or a
different drawing in the project), insert a destination arrow. Give it the same
code name that you gave to its source. AutoCAD Electrical reprocesses your
drawing set for wire numbering update. It matches source code names with
destination names and copies source wire numbers over to the destination
wire networks.
You can attach a source signal to a wire segment of a wire network. It enables
the wire number assigned to the network to jump and continue to another
network on the current drawing or on one or more drawings in the project.
The source and destination are also helpful with the Wire From/To reports
and connection information.
Attach a source signal arrow
1 Open AEGS03.dwg.
2 Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Signal Arrows
drop-down ➤ Source Arrow.
3 Respond to the prompts as follows:
1840 | Chapter 23 Tutorials