2011

Table Of Contents
Insert a one-line motor control circuit
In this exercise, you insert and configure a one-line motor control circuit using
Circuit Builder.
In the Project Manager, Project Drawing List, double-click One-Line.dwg.
One-Line.dwg contains a one-line bus. This wire is drawn on a wire layer
defined as No Wire Numbering. Such a wire layer behaves normally for
inserting, breaking, and scooting components. These wires also show up
in the from/to report. Wire numbers are not placed on these wires during
the Insert Wire Numbers process.
Insert the one-line circuit
1 Click Schematic tab Insert Components panel Circuit Builder
drop-down Circuit Builder.
The Circuit Selection dialog box displays.
2 Expand One-line Motor Circuit.
3 Select Vertical - FVNR - non reversing.
4 Click Configure.
5 Specify an insertion point on the one-line bus.
1792 | Chapter 23 Tutorials