2011

Moving the motor circuit up one line reference spacing opened up a bit more
room to add a new circuit below it. The next step is to extend the 3-phase bus
down to line reference 218 and over to the right to begin building a new motor
circuit.
Extending the 3-phase bus
1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Trim Wire.
2 Respond to the prompts as follows:
Fence/Crossing/Zext/<Select wire to TRIM>:
Click the bottom ends of the three dangling wires, right-click
You can insert vertical or horizontal 3-phase wiring. Three-phase wiring
automatically breaks and reconnects to any underlying components that
it finds in its path. If it crosses any existing wiring, wire-crossing gaps are
inserted.
3 Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Multiple
Bus.
4 In the Multiple Wire Bus dialog box, select:
Horizontal Spacing: 0.5
Vertical Spacing: 0.5
Starting at: Another Bus (Multiple Wires)
Number of Wires: 3
1774 | Chapter 23 Tutorials