2011

Specify wire start or [wireType/X=show connections]:
Click the wire connection point on the right-hand side of the switch contact (4)
Specify wire end or [Continue]:
Drag the wire to the right and click the wire connection point on the left-hand
side of the blue pilot light (5)
Specify wire start or [Scoot/wireType/X=show connections]:
Click the left-hand side of the switch contact
Specify wire end or [Continue]:
Drag the wire to the left and click the left-hand vertical bus wire
The wire automatically ends on the bus and inserts a wire connection
dot.
3 Repeat the process to connect the right-hand side of the blue pilot light
to the vertical bus wire.
4 Right-click and select Enter to finish creating the wire connections.
If you lay a wire over the top of a series of components, AutoCAD
Electrical automatically breaks and reconnects to the underlying wire
connection points.
Link components
1 Click Schematic tab ➤ Insert Components panel ➤ Dashed Link Line
drop-down ➤ Link Components with Dashed Line.
2 Respond to the prompts as follows:
Component to link from:
Click the contact of the switch on line reference 408 (6)
Component to link to:
Click anywhere on your new switch contact (7), right-click
1762 | Chapter 23 Tutorials