2011

Table Of Contents
Insert a system reset button
1 Click Schematic tab Insert Components panel Insert Components
drop-down Icon Menu.
2 In the Insert Component: JIC Schematic Symbols dialog box, click Push
Buttons.
3 In the JIC: Push Buttons dialog box, click Push Button NO.
4 Respond to the prompts as follows:
Specify insertion point:
Position the push button on the wire at line reference 403 near the hot wire
and click (1)
5 In the Insert/Edit Component dialog box, verify the following:
Component Tag: PB403
AutoCAD Electrical automatically assigned the tag name based on the
line reference.
6 In the Descriptions section, specify:
Line 1: SYSTEM
Line 2: RESET
7 In the Location code section, click Drawing.
8 In the All Locations - Drawing dialog box, select OPSTA3 and click OK.
9 In the Insert/Edit Component dialog box, click OK.
Inserting components continued | 1755