2011

13 Click OK to insert the WD_M block.
14 Set the default drawing properties such as component tagging, wire
numbering, cross-referencing, and so on.
NOTE No specific changes are needed for this tutorial.
15 Click OK.
16 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Create/Edit
Wire Type.
17 Add wire layers as needed. Set the properties, color, linetype, and
lineweight for each layer. For example:
■ In the Create/Edit Wire Type dialog box, click inside the Wire Color
column for a blank row and enter RED for a new wire layer.
■ Click inside the Size column and enter 12 for the size.
The Layer Name RED_12 is automatically created.
■ Click Color.
■ Select Red and click OK.
■ Click OK.
The layer is created and defined as a wire layer.
18 Enter SAVEAS at the command prompt.
19 Set the file type as AutoCAD Drawing Template (*.dwt).
20 Enter the file name, AEGS_ELECTRICAL.
21 Click Save.
The Template Options dialog box displays.
22 Select OK.
23 Close the drawing, AEGS_ELECTRICAL.DWT.
1732 | Chapter 23 Tutorials