2011

Table Of Contents
8 On the Insert dialog box, make sure the Explode option is not checked.
9 Click OK.
10 Specify the insertion point at 0,0,0.
11 If prompted for attribute values, leave them blank.
NOTE Attributes are invisible if no default values are assigned.
12 Click Schematic tab Other Tools panel Drawing Properties.
The alert displays.
13 Click OK to insert the WD_M block.
14 Set the default drawing properties such as component tagging, wire
numbering, cross-referencing, and so on.
NOTE No specific changes are needed for this tutorial.
15 Click OK.
16 Click Schematic tab Edit Wires/Wire Numbers panel Create/Edit
Wire Type.
WD_TB attribute method | 1717