2011

Table Of Contents
Finish mapping values from non-AutoCAD Electrical blocks
Use this utility to continue what you started with the Convert to Schematic
Component tool. Use it if you did not finish mapping values from your
non-AutoCAD Electrical block.
1 Click Conversion Tools tab Tools panel Map Attributes from Old
to New.
2 Select the block for additional attributes.
3 Optionally, select any non-AutoCAD Electrical block or text objects to
map values to the AutoCAD Electrical attributes and click Done.
Component annotation
These utilities replace non-AutoCAD Electrical blocks or graphics representing
symbols with AutoCAD Electrical blocks, transferring the attribute or text
values to the new AutoCAD Electrical block.
Convert to Schematic Component
Ribbon: Conversion Tools tab Tools panel Schematic Conversion
drop-down Convert to Schematic Component.
Toolbar: Conversion Tools
Menu: Projects Conversion Tools Convert Drawing Convert to
Schematic Component
Command entry: AEBLK2SCH
Map Attributes from Old to New
Ribbon: Conversion tab Tools panel Map Attributes from Old to
New.
1642 | Chapter 21 Conversion Tools