2011

Table Of Contents
Bypass terminal strips
Controls the wiring bypass of this component of one or more level categories
of supplementary terminal strips. For example, special signal wiring passes
from the currently edited component to some other components in a different
cubical/unit/ship split section. To disable any supplementary terminal strip
connections that might automatically be included in the from/to calculations
between this edited component and other connected components identified
in other level assignment combinations, switch all four bypass options on.
Sequence on Level 1
Influences the wire connection sequencing of the schematic components
whose physical footprints share the same combination of four level category
assignments. The sequence assignment is a 4-digit number (for example, 0001,
0002, and so on) and is sorted to give a default wire connection sequence.
For example, all of the push button and pilot light footprint representations
on a door layout carry the same Level 1 through Level 4 category code
assignments, but carry sequence value assignments that increase from left to
right and top to bottom on the layout. This means that AutoCAD Electrical
calculates the from/to connections for a common wire starting at the top left
and leaving the door at the component located in the bottom right-hand
corner.
Pick list for panel terminal strip report/graphical report
Pick list for panel terminal strip report/graphical
report
Select a supplementary terminal strip representation to display wiring
information inside of a report generator dialog box, and later insert a terminal
strip layout drawing.
Toolbar: Panel Level/Sequencing
Menu: Panel Layout Panel Level/Sequencing Panel Terminal Strip
Report
Command entry: AETERMINALSTRIPREPORT
All supplementary terminal strips found in the active drawing display in the
dialog box. Select from the list or click Pick to select the terminal strip from
the drawing. Once the terminal strip is selected (either from the list or the
active drawing), the report displays in the Report Generator dialog box.
1622 | Chapter 19 Panel Layout