2011

Check to skip any existing item numbers even if not fixed.Process blank items only
Project - process the entire project.Drawings to Process
Active drawing (all) - process components on the active
drawing only.
Active drawing (pick) - select the components for pro-
cessing.
Defines the manufacturers to process and the order to
process them. If you want to process only the components
with certain manufacturers or define the order:
Manufacturers to Process
■ Uncheck Process all. The list of all manufacturers used
in the project displays.
■ Check Allow duplicate item numbers to allow duplic-
ate item numbers between the selected manufacturers
and existing item numbers on components with unse-
lected manufacturers.
■ Use the Add and Remove buttons to indicate which
manufacturers to process. Select a manufacturer or
group of manufacturers and click Add or Remove.
■ Use the Move Up and Move Down buttons to change
the order of processing. Select a manufacturer or group
of manufacturers and click Move Up or Move Down.
The default order is alphabetical.
NOTE The default process order is alphabetical.
See also:
■
Item Numbering Setup on page 211
Fixing item numbers
Assign an item or detail number to the main part number of a component or
each multiple catalog part number through the Insert/Edit dialog box. If you
do not want an item number to change when you run
Resequence Item
Numbers
on page 1602 later on, mark an item number as fixed.
Fixing item numbers | 1605