2011

at the right; or you can enter your own format using replaceable parameters
on page 236.
Parameters must be separated by non-blank delimiters for AutoCAD Electrical
to be able to re-extract wiring diagram information into reports. For example,
"%T=%W %1 %G" is not acceptable because there is only a space between the
%W and %1 and %G parameters. Acceptable formats include "%T=%W (%1)
%G" or "%T=%W / %1 (%G)" or "%T=%W (%1) %G".
NOTE You cannot use commas in the format. They signal multiple wire connection
annotations onto a single wire connection attribute.
Additional options for the "To" component tag
Additional options to include in the text.
Adds the terminal text as a suffix.Add terminal pin as a suffix to tag
Adds any terminal description value as a suffix.Add terminal description to tag
Adds any installation value as a prefix.Include installation prefix to IEC tag
format
View/Test
Allows a preview or test of the report.
Suppress any duplicated annotation on each terminal
Indicates to hide duplicated annotations so that they do not show on the
report.
Delimiter between multiple instances on same line of text
Enter the character used to separate multiple panel wire annotation values
for the same wire connection.
If wire numbering converts to MText
The default MText insertion point is the same as the insertion point of the
footprint block. The default text size either matches that of existing wire
number attributes found on the footprint symbol or, if none present, the
MText size is forced to match the current value of the AutoCAD system variable
"TEXTSIZE".
Add wire information to footprints | 1591