2011

Run any of the component, footprint, or terminal insertion from list
commands (such as
Insert Component (Panel List) on page 790).Select the
drawings to process and click OK. Select multiple components or terminals
to insert and click Insert.
The components display in the list box in the order they are inserted. To
modify the order, select an item from the list, then select Move Up or Move
Down in the list.
Specifies the location for each component or terminal
using the Insert dialog box.
Prompt for each location
(for component insertion only) Specifies the location
for all the components. Specify the insertion points
Fence Insertion
on the drawing and right-click. The Insert/Edit dialog
box displays. Once you click OK on the Insert/Edit
dialog box, the component inserts on the drawing.
Specifies the location for the first component (or
terminal). The values in the X-distance and Y-distance
Use uniform spacing
boxes are used to calculate the insertion coordinates
for the remaining components (or terminals).
NOTE You can set the default values for the X-dis-
tance and Y-distance in the Panel Configuration dia-
log box.
(for footprint insertion only) Suppresses the edit
dialog box that normally appears each time a com-
Suppress edit dialog and prompts
ponent (or terminal) is inserted. The Panel Insert/Edit
dialog box displays after each insert if this option is
not selected.
Moves the selected component or terminal up one
spot in the list.
Move Up
Moves the selected component or terminal down
one spot in the list.
Move Down
Rearranges the list of terminals in descending order.Reverse
Sorts the list of terminals in ascending order.Re-sort
Insert panel footprints from a schematic list | 1543