2011

can insert with smart AutoCAD Electrical attributes added automatically, on
the fly.
There are five attribute template drawings:
component footprintswd_ptag_addattr_comp.dwg
terminal footprintswd_ptag_addattr_trm.dwg
terminal with wire no. as terminal numberwd_ptag_addattr_wtrm.dwg
balloonswd_ptag_addattr_itemballoon.dwg
terminal footprints (when inserted by
Level/Sequencing tools)
Wd_ptag_addattr_pnltermstrip.dwg
If the appropriate attribute template exists, the following steps are performed
when a panel footprint is inserted.
1 Find the center of the footprint by collecting and averaging the objects
that make up the footprint.
2 Insert the attribute template at the calculated center of the footprint.
3 Make sure there are no duplicate attributes. If duplicate attributes are
found, the attribute from the footprint is kept.
4 Reblock the added attributes with the inserted footprint.
5 Add the schematic data to the footprint. If the target attribute exists, the
data is added as attribute data. If the target attribute does not exist, the
data is added as invisible Xdata.
Uncheck the Enabled check box if you do not want AutoCAD Electrical to
search for the attribute template drawing. If enabled, select a scale factor, 1.0
to insert as is, or select to scale to a specific text height.
Panel wire connection report XYZ offset reference
Specifies the x, y, or z-offset value for the mtext added next to a panel
component when adding the wire connection information. Use the Setup
button to define the default wire connection text format.
Format: schematic layout wire connection
annotation
Panel drawing configuration and defaults | 1529