2011

Table Of Contents
Ribbon: Reports tab Miscellaneous panel Report Format Setup.
Toolbar: Schematic Reports
Menu: Projects Reports Report Format File Setup
Command entry: AEFORMATFILE
Select Missing Bill of Material from the Schematic report list.
Category
By default, the report lists schematic components. Select a different Category
to run the report for one-line, one-line bus-tap, hydraulic, pneumatic, P&ID,
or user-defined components. These components are each identified by a unique
WDTYPE attribute on page 325 value.
Options
Specifies whether to include components, cable markers, connectors, or
terminals in the report. You can select one or multiple options to include.
Installation Codes to Extract
Extracts only the information for components with specific installation values.
Indicate to process all components, components without an installation code,
or only components marked with an installation code that matches that
entered in the edit box. Wild-cards are supported.
Once you pick the Named Installation button, you can simply type the
installation code in the box or click the List: Drawing or List: Project button
to select from a list of used installation codes.
Location Codes to Extract
Extracts only the information for components with specific location values.
Indicate to process all components, components without a location code, or
only components marked with a location code that matches that entered in
the edit box. Wild-cards are supported.
Once you pick the Named Location button, you can simply type the location
code in the box or click the List: Drawing or List: Project button to select from
a list of used location codes.
Overview of format files | 1481