2011

List
Lists drawings that appear to be out-of-date with the wire connection table
of the project.
Freshen Wire Connection Table
Specifies for AutoCAD Electrical to update the wire connection table to include
any out-of-date drawing files.
Format
Changes the format of the extracted data. The dialog box lists the format files
to select from.
Location code selection for from/to reporting
When you select to run a Wire From/To report, AutoCAD Electrical extracts
component, terminal, location code, and wire connection information from
the selected drawings. This dialog box allows you to make your report’s “from”
and “to” location selections. All the location codes AutoCAD Electrical found
on the drawing set are listed on each side of this dialog box. Location “(??)”
is also included in the list if AutoCAD Electrical found any component or
stand-alone terminals that did not have an assigned location code.
Ribbon: Reports tab ➤ Schematic panel ➤ Reports.
Toolbar: Main Electrical 2
Menu: Projects ➤ Reports ➤ Schematic Reports
Command entry: AESCHEMATICREPORT
Select Wire From/To from the report list. Specify whether to process the project,
active drawing, or selected wires.
Select location codes from the left and right-hand lists to build the report’s
from/to combinations shown in the middle of the dialog box. Click OK to
display the report. AutoCAD Electrical quickly filters and formats the extracted
data and presents it in the Report Generator dialog box. You can then save it
Generate schematic reports | 1425