2011

Format
Changes the format of the extracted data. The dialog box lists the format files
to select from.
Schematic wire from/to
If you marked components and/or terminals with location codes, you can
make good use of this report. AutoCAD Electrical first extracts component,
terminal, location code, and wire connection information from every drawing
in the project set. Then it displays a location list dialog box where you can
make your report's "from" and "to" location selections. All the location codes
AutoCAD Electrical found on the drawing set are listed on each side of this
dialog box. Location "(??)" is also included in the list if AutoCAD Electrical
found any component or stand-alone terminal that didn't have an assigned
location code.
Ribbon: Reports tab ➤ Schematic panel ➤ Reports.
Toolbar: Main Electrical 2
Menu: Projects ➤ Reports ➤ Schematic Reports
Command entry: AESCHEMATICREPORT
Select Wire From/To from the report list.
Specify whether to process the project, the active drawing, or selected wires.
Category
By default, the report lists schematic components. Select a different Category
to run the report for one-line, one-line bus-tap, hydraulic, pneumatic, P&ID,
or user-defined components. These components are each identified by a unique
WDTYPE attribute on page 325 value.
List
Lists drawings that appear to be out-of-date with the wire connection table
of the project.
Freshen Wire Connection Table
Specifies for AutoCAD Electrical to update the wire connection table to include
any out-of-date drawing files.
1418 | Chapter 18 Reports