2011

Table Of Contents
Select Missing Bill of Material from the report list.
Specify whether to process the project or the active drawing.
Category
By default, the report lists schematic components. Select a different Category
to run the report for one-line, one-line bus-tap, hydraulic, pneumatic, P&ID,
or user-defined components. These components are each identified by a unique
WDTYPE attribute on page 325 value.
Options
Specifies to include components, cable markers, connectors, or terminals in
the report.
Installation Codes to Extract
Extracts only the information for components with specific installation values.
Indicate to process all components that carry part number values, components
without an installation code, or only components marked with a location
code that matches that entered in the edit box. Wild cards are supported.
After you click Named Installation, type the installation code in the box, or
click List: Drawing or List: Project to select from a list of used installation
codes. You can also create a report from multiple installation codes. AutoCAD
Electrical automatically creates a comma-delimited list for the named
installation search.
Location Codes to Extract
Extracts only the information for components with specific location values.
Indicate to process all components that carry part number values, components
without a location code, or only components marked with a location code
that matches that entered in the edit box. For example, BOM report for
components marked "OP STA 2." Wild cards are supported.
After you click Named Location, type the location code in the box, or click
List: Drawing or List: Project to select from a list of used location codes. You
can also create a report from multiple location codes. AutoCAD Electrical
automatically creates a comma-delimited list for the named location search.
Freshen Project Database
Specifies for AutoCAD Electrical to update the project database to include any
out-of-date drawing files.
Generate schematic reports | 1417