2011

wire connection point and follows the connected wire. The first terminal
symbol, fuse symbol, or connector symbol that is hit reports in the column
marked with default "TERMTAG" label. The first schematic component reports
in the column with the "CMPTAG" label. If there are multiple instances, the
one closest to the PLC I/O point is the one that shows up in the report column.
PLC Modules Used So Far report
For this report, AutoCAD Electrical quickly scans the wiring diagram set. It
returns in a few moments and displays the I/O modules it finds. Each entry
shows the beginning and ending address of the module.
Terminal Numbers report
This project-wide, stand-alone report lists all instances of terminals. Each entry
includes information tied directly to the terminal such as terminal number,
terminal strip number, and location code.
Terminal Plan report
This project-wide, stand-alone report does a wire network extraction. It takes
longer to generate, but the report includes wire number and wire layer name
information.
Connector Summary report
This report lists a single line for each connector tag along with pins used,
maximum pins allowed (if the parent carries the PINLIST information), and
a list of any repeated pin numbers used. You can run this report across the
project or for a single component.
Connector Details report
This report extracts the component wire connection data and displays it in a
dialog box. Each entry shows a connection to a component, the wire number,
component tag name, terminal pin number, component location code (if
present), and the layer that the connected wire is on.
Cable Summary report
This project-wide cable conductor report gives a report listing all the cable
marker tags (parent tags) found.
Generate schematic reports | 1401