2011

First New Section Placement
Specifies where to place the table in the drawing. You can enter x and y values
or pick a point on the screen. The table appears at the specified coordinates
once you click the OK button.
Row Definition
Specifies the number of table rows, the start and end lines, the number of
rows for each section, and whether to build the table from the bottom up.
The starting and ending lines reflect the total number of rows
displayed in the Report Generator dialog box. These values default
to previously used values on subsequent runs of the report.
Start Line/End
Creates the table from the bottom to the top; meaning that the
last line is created first and the first line is created last. The table
Build Up
title appears at the bottom of the report table when this option
is selected.
Breaks the table sections based upon the selected break criteria.
For example, if you select Manufacturer as the Special Break and
Apply Special Breaks
there are 15 different manufacturers in the report, your report
will be broken into 15 sections.
Specifies the maximum number of rows for the table or section,
determining when to split the table.
Rows for Each Section/Rows
Directs AutoCAD Electrical to add blank lines at the end of a table
section if necessary until the number of rows equals the Rows
Force to Maximum Rows
setting. Individual records cannot be split into two separate sec-
tions.
Section Definition
Defines the number of sections on the drawing and the distance between
sections on the same drawing. If the Sections value is set to 1, the X-Distance
and Y-Distance options are disabled.
Specifies the maximum number of table sections for this report.
A blank value indicates an unlimited number of sections on one
drawing.
Sections
Specifies the X-distance from the end of one table section to the
beginning of the next. The sections are on the same drawing.
X-Distance
Generate reports | 1321