2011

Run an optional script file containing a list of com-
mands to execute AFTER the plot command is issued.
Run a post-plot command script file
The default script file name is postplot.scr, located
in AutoCAD Electrical user subdirectory.
NOTE Changes to drawings are not saved during
the plotting process. Additionally, the plot time and
date stamp text is discarded after the plot is com-
plete. To preserve changes made during the plotting
process, add the QSAVE command into the pre- or
post-plot script file.
Output device name
A plotter configuration file contains information such as the device driver and model, the output
port to which the device is connected, and various device-specific settings.
Use an existing plotter configuration file (.pc3).Use plot config (.pc3)
Use the default plotter configuration.Use layout tab's default
NOTE If you are plotting to a file you must also select the Yes: plot to= option.
The plot file name is generated automatically based on the drawing name. The
plot folder is the same as the drawing.
Detailed plot configuration mode
Turns detailed plot configuration options on or off.
Enter an optional page setup name when plot
configuration options are turned off.
Optional page setup name
Select an option for the pick list when plot con-
figuration options are turned off.
Pick list (from current drawing)
Plot to file
Enter a subdirectory to plot to or leave blank to plot to the subdirectory where
the drawings are located.
1192 | Chapter 15 Project-Wide Tools