2011

Displays the plug and receptacle pin numbers for the selected row.
Enter a new value in the edit box or click the arrows to increment or
decrement both numbers on the plug and receptacle.
Pin Numbers
NOTE If you replace pin numbers through editing, the replaced pin
numbers may go back into the Pin List if they were originally defined
in the Pin List range.
Edits the plug and receptacle terminal descriptions. The value you
enter in the edit box displays in the Description column of the grid.
Pin Descriptions
Bend wires at right angles
Bend wires at right angles
Bends a wire in a right angle and makes three right angle turns to avoid or
add geometry.
You can modify the wire defined at a right angle. You can replace the right
angle bend while maintaining the original wire connections to the
components.
NOTE This tool terminates if the bend attempts to connect two different wire
networks or if the bend bypasses more than a single right-angle turn.
1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify Wires
drop-down ➤ Bend Wire.
2 Select one of the two wires that make up a right-angle turn.
Bend wires at right angles | 1161