2011

Table Of Contents
A preview outline of the connector displays for placement on the drawing.
It shows rounded corners for the plug side of the connector. An 'x'
indicates the insertion point of the connector and the arrow indicates
the plug side wire connection direction.
8 Specify the insertion point on the drawing or enter Z (zoom), P (pan), X,
V, or Tab at the command prompt to change the connector orientation
before insertion. Review the sections below to see how Tab, V key, or X
key changes your connector orientation.
If you selected to allow spacers/breaks, in the Custom Pin Spaces/Breaks
dialog box, click Break Symbol Now to break the connector and display
the Connector Layout dialog box for defining how you want the rest of
the pins inserted on the drawing.
Reverse connector using the Tab key
Prior to committing the connector outline to the drawing, you can press Tab
to reverse the connector either about its long axis or end for end. If the
connector is vertical, a series of TAB keystrokes cycles the image through these
four orientations:
TAB 3TAB 2TAB 1Start point
Rotate connector using the V key
Press "V" at the command prompt to switch between vertical and horizontal
orientations. Based on where the outline is in the flip process, the Tab keystroke
reverses the connector either about its long axis or end for end. When in its
Use point-to-point wiring tools | 1141