2011

Table Of Contents
Moves the selected terminal up or down one level
within the terminal definition.
Move Up/Move Down
Edit/Delete Jumpers
Use this to edit the jumper information, such as catalog data, remove terminals
from a jumper, or delete a jumper.
Ribbon: Panel tab Terminal Footprints panel Editor.
Toolbar: Panel Layout
Menu: Panel Layout Terminal Strip Editor
Command entry: AETSE
Make your selection on the Terminal Strip Selection dialog box and click Edit.
Select the terminals with the jumper defined and select the Edit/Delete Jumper
tool.
Lists all of the jumpers, grouped by Jumper ID, at-
tached to the selected terminal. If this dialog box
Jumpers to Terminals
is used within the Assign Jumper function, only the
jumper being assigned is displayed.
NOTE You cannot assign a jumper between termin-
als from different terminal strips using Terminal
Strip Editor. If a jumper across terminals strips exists,
it is displayed but you cannot modify it using Ter-
minal Strip Editor. It must be modified using the
Edit Jumper on page 1123 tool.
Specifies the catalog data for the jumper between
the primary terminal and the selected terminal.
Catalog Data
Manufacturer: Specifies the manufacturer
name.
Catalog: Specifies the catalog number.
Assembly: Specifies the assembly code.
Item: Specifies the item value.
Count: Specifies how the catalog data is used
in the Bill of Materials. When multiple terminals
1108 | Chapter 13 Terminal Tools