2011

Table Of Contents
Toolbar: Panel Layout
Menu: Panel Layout Terminal Strip Editor
Command entry: AETSE
Make your selection on the Terminal Strip Selection dialog box and click Edit.
On the Terminal Strip, Catalog Code Assignment, or Cable Information tab,
select the level to modify. In the Terminals section, click Edit Terminal.
Changes the installation codes. Click Browse to
display a list of existing installation values found in
Installation Code
the active drawing, entire project, or an external
list (default.inst). Pick from the list to update the
component automatically with the installation code.
Changes the location codes. Click Browse to display
a list of existing location values found in the active
Location Code
drawing, entire project, or an external list (de-
fault.inst). Pick from the list to automatically update
the component automatically with the location
code.
Specifies the Tag ID given to the terminal strip. If
there is an existing name, it appears in the edit box.
Terminal Strip
If not, you can enter a specific ID name or click the
< and > buttons to increment or decrement the last
digit/character in the Tag Strip value.
Specifies the ID number for the terminal. If the
catalog values of the terminal carry PINLIST inform-
Number
ation, you can step through the available pin
numbers using < or >. If there is not PINLIST inform-
ation, these buttons just increment or decrement
the terminal number. You can also click Pick to se-
lect a text object or an attribute on the active
drawing to use for the terminal number.
When inserting a new terminal, the highest terminal
number in the strip is identified and the default
terminal number for the new terminal increments
by 1.
Use the terminal strip editor | 1099