2011

Table Of Contents
unless the option Insert All Sections on Active
Drawing is selected.
NOTE The Insert All Sections on Active Drawing
option is not available when using the Terminal
Strip Table Generator tool.
Specifies where to place the table in the drawing.
You can enter x and y values or pick a point on the
screen.
Section Placement
Specifies the distance between sections, offset dir-
ection, and the base point for the distance measure-
ment.
Section Offset
Distance: Specifies the distance between sec-
tions.
Direction: Specifies the direction for the offset.
Base Point: Specifies the base point for the
distance measurement between sections.
Specifies the scale and angle of the table sections
when inserted. These settings are reflected in the
preview.
Scale/Angle on Insert
Drawing Information for Table Output
First Drawing Name: Specifies a starting
drawing file location and file name to use for
the automatic creation of the drawing files. The
drawings are automatically added to the active
project and display at the end of the drawing
list in the Project Manager. The last character
of the drawing file name is incremented for
each drawing created.
Template: Specifies the template file to use for
any new drawings. Enter a template file name
or click Browse to search for and select a tem-
plate file.
Select to display all rows for each terminal even if
there is no connected component. The Wires per
Show Unused Wire Connections in Table
Connection value for the terminal defines the
number of rows.
Use the terminal strip editor | 1095