2011

Lists the pin numbers defined on the right side of
the terminal block. This data is entered into the
PinR
LnnPINR attribute if present; otherwise, it is placed
into xdata.
Lists the reference location of the terminal symbol
in the project. The syntax is ‘Sheet,Reference’ based
on the drawing configuration.
Reference
NOTE This area is disabled if the terminal is a one-line symbol. Multi-level or panel
relationships are not supported for one-line terminals.
Project List
These controls allow for quick selection of terminal strips and terminal
numbers used throughout the active project.
Shows all the previously defined terminal strips in
the active project.
Project List
When inserting a new terminal, this list is populated
with the Installation, Location and TAGSTRIP values
of the previously inserted terminal.
Lists all terminal numbers found, either drawing-
wide or project-wide, whose Tag Strip value
matches the highlighted Tag Strip value.
Numbers Used
Catalog Data
You can do a drawing-wide or project-wide listing of similar terminals with
their catalog assignments. During your editing session, the last MFG / CAT /
ASSYCODE assignment for each terminal type you insert into your wiring
diagram is remembered. When you insert another terminal of that type, the
catalog assignment of the previous terminal is set as the default (assuming a
previous one was made during the current editing session).
Lists the manufacturer name for the terminal. Enter a value or
select one from the Catalog lookup.
Manufacturer
Lists the catalog number for the terminal. Enter a value or select
one from the Catalog lookup.
Catalog
1044 | Chapter 13 Terminal Tools