2011

Defining the sequence gives you control over how AutoCAD Electrical analyzes
the circuits including:
■ The order of the contents in the WFRM2ALL table in the project database
file
■ How from/to connection information is output to various reports
■ Annotation on physical footprint representations (using the Wire
Annotation of Panel Footprint
on page 1588 tool).
NOTE You can also access it by right-clicking on any segment of a wire network
and selecting Wire Sequence ➤ Edit Wire Sequence.
Provides these features to define the sequence order:
■ Sort the components by physical location.
■ Move the components up or down in the listing.
■ Pick mode, in the active drawing only, where you pick the wire connection
points to define the connection sequence.
Once you specify the sequencing, you can use the Show Wire Sequences tool
to view the sequence or use the Wire From/To reporting tool to see how the
sequencing is reported.
NOTE Your dialog box differs depending on whether you selected to modify the
sequence of a wire network that is connected to a terminal. When a terminal is
part of the selected wire network, you have an option to define secondary
Direct-to-Terminal wire connection sequences.
Lists the wires and terminals found in the circuit.
The * indicates that the wire is on another drawing
Wire Connection Sequence
and the “t” indicates that the entry is a terminal
and a candidate for a direct-to-terminal secondary
sequence definition.
NOTE Components connected on the far side of
a terminal (on a side opposite of the picked wire
network) are not displayed in the list, even if the
terminal is one that does not change the wire
number through it.
Control from/to report connection sequencing | 1035