2011

1 Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Insert Dot,
Tee Markers drop-down ➤ Insert Angled Tee Markers.
2 Select at or near the intersection point.
If a dot marker is present, it is deleted and replaced by the angled tee
symbol.
3 After the symbol inserts and reconnects to the wiring, press the spacebar
or Enter to switch the inserted tee through four different orientations.
Press Esc when the appropriate orientation displays.
NOTE To change the orientation of the tee symbol after insertion, right-click
on the marker and select Toggle Angled Tee Markers (or select the tool from
the ribbon or toolbar). To customize the appearance of these symbols, edit
the tee symbols stored in the selected schematic symbol library. These tee
symbol names are HT0_###.dwg and VT0_###.dwg where # = combinations
of 1,2,4, and 8. Each symbol carries attribute WDWSEQ with a three-digit
value indicating wire connection sequence priority for the three wire
connection points of the symbol.
Right-click the marker and select Delete Component to remove an inserted
tee connection symbol and heal the wires.
Toggle angled tee markers
Toggles an existing angled tee connection symbol, or windowed symbols,
through a total of four possible orientations.
Right-click or press the spacebar to step through the various tee connection
orientations. Press ESC when the appropriate orientation displays.
Control from/to report connection sequencing | 1033