2011

NOTE Pick Mode is unavailable when you are working with a wire network
that crosses multiple drawing files. If you are working with wire networks that
jump to one or more additional drawings, click Freshen to update the wire
connectivity database with any out-of-date files.
4 (Optional) To connect additional components directly to a given terminal,
select the components and the terminal (marked with a “t” in the
left-hand column) in the Wire Connection Sequence list and click Add.
A copy of the terminal and the actual component move to the
Direct-to-Terminal Secondary Sequences list at the bottom of the dialog
box. You can then click Move Up or Move Down to change the order of
the sequence (if you selected two or more devices plus a terminal) or
remove a sequence by selecting the sequence and clicking Reset.
5 Click OK-new.
Writes the sequence information back to the component wire connections
(as Xdata on the wire connection attributes and optionally to terminal
symbols in the case of Direct-to-Terminal Secondary sequencing).
6 (Optional) Right-click a wire on the wire network and select Wire Sequence
➤ Show Wire Sequence. Press the spacebar to advance through the
sequence.
You can also view the results of your sequencing by running the Wire
From/To report.
Show a defined wire sequence
Show the defined wire sequence on the selected wire network. You can also
right-click any wire segment in the wire network to access this tool.
1030 | Chapter 12 Wire/Wire Number Tools