2011

TIP Use the Toggle Wire Number In-Line tool to move a wire number from
above/below the wire to in-line. If the wire number is already in-line, the wire
number moves to the position defined in the Drawing properties: wire numbers
tab
on page 225.
Toggle wire number position
Switches a wire number between drawing properties above or below and
in-line.
If the wire number you select is in-line, it switches to above or below based
on the drawing properties. If it starts as above or below, the selected wire
number switches to in-line.
NOTE If there is not room for a wire number to become an in-line wire number,
it remains an above or below line wire number.
TIP Use the Flip Wire Number tool to switch a wire number between above and
below the wire.
1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Toggle Wire
Number In-line.
2 Select the wire number to toggle. You can select on the wire number or
on the wire itself.
3 Right-click to exit the command.
Apply drawing-specific wire number settings. These settings are maintained
inside the WD_M block in the drawing.
Reposition Wire Numbers | 1003