2011

that a new sequential wire number tag is not repeated on
any other drawing.
If you set DEMO1 to 100 and DEMO2 to 200, the wire
numbers on DEMO1 start at 100 and wire numbers on
DEMO2 start at 200. If DEMO1 has more than 100 wire
numbers it starts using wire number 200 and above.
DEMO2 would begin its wire numbers where DEMO1 left
off (making sure that duplicate wire numbers are not as-
signed).
The default is "1." Setting it to "2" with a starting sequential
of "1" would yield wire numbers 1, 3, 5, 7, 9, 11, and so
on.
Increment
Sets the wire number tag suffix. This list is used to create
unique reference-based wire number tags for multiple wire
Line Reference
networks beginning at the same reference location (such
as wire network beginning at a location per line reference
number, X-Y grid reference, or X-Zone reference).
Displays a suffix list. List suffix characters for wire numbers
beginning on the same line reference or in the same zone
Suffix Setup
(to keep wire numbers unique). Select one of the four
predefined suffix lists or enter your own custom suffix list.
New Wire Number Placement
NOTE The Insert Wire Number tool does not take the current wire number setting
(in-line, above or below) into account when updating existing wire numbers. This
setting is used only when inserting new wire numbers. Use the Toggle Wire Number
In-Line tool for flipping existing wire numbers among the three modes.
Places the wire number above the physical wire.Above Wire
Places the wire number inline with the wire.In-Line
Defines spacing between the inline wire number and the wire it-
self.
Gap Setup
Places the wire number below the physical wire.Below Wire
Set wire number placement | 981