2008

Marked with "+[29]" followed by 0= normal wire numbering
mode or 1=calculate reference-based wire number based
Wire number terminal override
on the location not the first terminal in the wire network
(or revert to normal wire numbering mode if no terminal
in the network).
Marked with "+[30]" and set as a global variable (default
is 0.0) to aid in the calculation of the "CLEN" column (cal-
Calculation of the "CLEN" column
culated wire length) in a from/to report that is able to map
schematic wire connections to panel physical layouts. This
value is the extra amount to add to each end of a calculated
wire segment for connection purposes.
Marked with "+[31]" and set in the Project Properties dialog
box. The value can be blank (no sort order override) or 0-
Tag/Wire number order
7 for the various horizontal/vertical sort orders listed in the
dialog box.
Marked with "+[32]" followed by 0= real-time error checking
mode is “off”, 1= mode is “on.”
Real-time error checking
Marked with "+[33]" to indicate a string of column names
used in grid column headers in the Wire Type commands.
Grid column headers
Marked with "+[34]" to suppress the dash (-) if it is the first
character of a tag when the Combined installation/location
component tag mode is “on.” See the [+10} entry.
Suppress dash
All remaining entries give time relative path (relative to the
location of the project’s .wdp file itself) to each drawing
Project drawing list
that is part of the project. The drawing name is given first.
Then, if special assignments or descriptions are defined for
the drawing, this information follows the drawing name in
subsequent lines. Each line is prefixed with a code. If special
"sec/sub" groupings are defined, then a drawing's "sec" is
preceded by a "=" entry and "sub" by a "==" entry. If one
to three lines of description are defined, each is preceded
by a "===" entry. If a drawing is marked "Ref only", it is
preceded by a "====REF" entry.
Overview of the project file format | 81