2008

PLC I/O Address and Description report
This report lists each PLC module and its beginning and ending I/O address
numbers. It scans your drawing set and returns all individual I/O connection
points it finds. This includes up to five lines of description text and the
connected wire number for each I/O point.
PLC I/O Component Connection report
This report scans the selected drawing(s) and returns information about any
components connected to PLC I/O points. Data for the report starts at each
wire connection point and follows the connected wire. The first terminal
symbol, fuse symbol, or connector symbol that is hit reports in the column
marked with default "TERMTAG" label. The first schematic component reports
in the column with the "CMPTAG" label. If there are multiple instances, the
one closest to the PLC I/O point is the one that shows up in the report column.
PLC Modules Used So Far report
For this report, AutoCAD Electrical quickly scans the wiring diagram set. It
returns in a few moments and displays the I/O modules it finds. Each entry
shows the module's beginning and ending address.
Terminal Numbers report
This project-wide, stand-alone report lists all instances of terminals. Each entry
includes information tied directly to the terminal such as terminal number,
terminal strip number, and location code.
Terminal Plan report
This project-wide, stand-alone report does a wire network extraction. This
means it takes longer to generate, but the report includes wire number and
wire layer name information.
Connector Summary report
This report lists a single line for each connector tag along with pins used,
maximum pins allowed (if the parent carries the PINLIST information), and
a list of any repeated pin numbers used. You can run this report across the
project or for a single component.
Generate schematic reports | 899