2008

specified information into the report generator for printing, saving to a file,
or placing in a table on the drawing.
Displays all component tag names in the report.Tag Name
Eliminates any duplicate pin numbers for the selected
plug from the report.
Remove duplicated pin numbers
Displays the wiring information from the left or right
side of the pin symbols. This displays what is connec-
ted to the pin and the wiring information.
Left Side / Right Side
Identifys additional pin numbering not defined in
the schematic for spare pin connections. For ex-
Fill In Missing Pin Numbers
ample, the connector may have used 4 out of 9 pins
in the schematic and those are the connections that
are being reported. You can then display the 5 spare
pin connections by selecting this check box and
identifying the first pin number as 1 and the last as
9. Label for spares displays a text string under the
wire number column in the report.
Internal/external codes left/right
(for Terminal Plan Report only) Allows the Terminal Plan report to take
advantage of terminals that have the optional "I" (Internal) and "E" (external)
codes on the wire connection. With this check box selected, you can select
from the radio buttons below it to sort within an entry. You can show all of
the Internal or External connections on the left or on the right of the wire
connection.
Squeeze
Specifies whether to reduce the width of the report. Select 1 for maximum
squeezing and 3 for minimum squeezing.
Add blanks between entries
Adds a blank line between report entries.
814 | Chapter 14 Reports