2008

2 Click the Toggle Angled Tee Markers tool.
3 Select or window the tee connections to change.
4 Right-click or press the spacebar to toggle through the various
tee connection orientations, and press Esc when the desired
one displays. This replaces any dot tee symbols with angled
tee symbols and then toggles through the 4 possible orienta-
tions for each.
Edit wire connection sequence
This tool defines the wire connection sequence of any wire networks containing
three or more interconnected devices. Doing this gives you control over how
AutoCAD Electrical analyzes the circuits (such as the order of the contents in
the WFRM2ALL table in the project’s scratch database file) and how from/to
connection information is output to various reports or annotated on physical
footprint representations (using the Panel Layout ➤ Wire Annotation of
Panel Footprint tool).
Access:
Click the arrow on the Insert Wire tool to access the Edit Wire Sequence tool.
Click Wires ➤ Wire Miscellaneous ➤ Edit Wire Sequence.
NOTE You can also access this by right-clicking on any segment of a wire network
and selecting Wire Sequence ➤ Edit Wire Sequence.
Provides tools to define the desired sequence order, such as sorting the
components by physical location, moving the components up or down in the
listing, and going into a pick mode (in the active drawing only) where you
can pick the wire connection points in order to define the connection
sequence.
Once you specify the sequencing, you can use the Show Wire Sequences tool
to view the sequence or use the Wire From/To reporting tool to see how the
sequencing is reported.
Control from/to report connection sequencing | 533