2008

NOTE For these dot and angled tee markers to insert automatically as each wire
tee intersection is created, set the default Wire Tee connection in the Wiring Style
section of the Drawing Properties ➤ Styles dialog box.
1 Click the arrow on the Wire Tee Markers tool to access the
Insert Angled Tee Markers tool.
2 Click the Insert Angled Tee Markers tool.
3 Select at or near the intersection point.
If a dot marker is present, it is deleted and replaced by the
angled tee symbol.
4 After the symbol inserts and reconnects to the wiring, press
the spacebar or Enter to switch the inserted tee through 4 dif-
ferent orientations. Press Esc when the appropriate orientation
displays.
NOTE If you want to change the tee symbol's orientation after
insertion, right-click on the marker and select Toggle Angled Tee
Markers (or select the tool from the toolbar). To customize the
appearance of these symbols, edit the tee symbols stored in the
selected schematic symbol library. These tee symbol names are
HT0_###.dwg and VT0_###.dwg where # = combinations of
1,2,4, and 8. Be aware that each symbol carries attribute WDWSEQ
with a three-digit value indicating wire connection sequence pri-
ority for the three wire connection points of the symbol.
Right-click on the marker and select Delete Component to re-
move an inserted tee connection symbol and heal the wires.
Toggle angled tee markers
This toggles an existing angled tee connection symbol (or windowed symbols)
through a total of 4 possible orientations.
1 Click the arrow on the Wire Tee Markers tool to access the
Toggle Angled Tee Markers tool.
532 | Chapter 8 Wire/Wire Number Tools