2008

Edit a wire sequence
This tool predefines a wire network's connection sequence. The network can
be either fully contained on the active drawing or pass across multiple drawings
using signal source/destination symbols.
1 Click the arrow on the Insert Wire tool to access the Edit Wire
Sequence tool.
2 Click the Edit Wire Sequence tool.
NOTE You can also access this tool by right-clicking on any wire
segment in the wire network.
3 Select any wire segment on the wire network you want to
process.
4 On the Edit Wire Connection Sequence dialog box, adjust the
connection to connection sequencing in the list by clicking
Move Up or Move Down or click Pick Mode to define the se-
quencing by actual picks at each wire connection point.
NOTE Pick Mode is unavailable when you are working with a wire
network that crosses multiple drawing files. If you are working
with wire networks that jump to one or more additional drawings,
click Freshen to update the wire connectivity database with any
out-of-date files.
5 (Optional) To directly connect additional components to a
given terminal, select the components and the terminal
(marked with a “t” in the left-hand column) in the Wire
Connection Sequence list and click Add.
A copy of the terminal and the actual component move to the
Direct-to-Terminal Secondary Sequences list at the bottom of
the dialog box. You can then click Move Up or Move Down
to change the order of the sequence (if you’ve selected two or
more devices plus a terminal) or remove a sequence by selecting
the sequence and clicking Reset.
6 Click OK-new.
This writes the sequence information back to the component
Control from/to report connection sequencing | 529