2008

TIP Change the position of an existing wire number using the Toggle Wire Number
In-Line tool.
1 Click the Project Manager tool.
2 In the Project Manager, right-click on the project
name and select Properties (or click the drawing name,
and select Properties ➤ Drawing Properties).
If you change this setting in the project properties,
the drawings already in the project do not get this
setting.
NOTE You can also automatically set wire number
placement using the Drawing Properties tool. Follow the
steps below.
3 In the Project or Drawing Properties dialog box, click
the Wire Numbers tab.
4 In the Wire Number Placement section, select how
you want to automatically place new wire numbers:
above, below, or inline of the wire.
■ Above Wire: Places the wire number above the physical
wire.
■ In-Line: Places the wire number in line with the wire. Click
Gap Setup to define the spacing between the wire number
and the wire itself.
■ Below Wire: Places the wire number below the physical
wire.
5 Click OK.
NOTE Use the Copy Wire Number (In-Line) tool to insert individual wire numbers
inline with the wire rather than above or below the wire in the active drawing.
Drawing properties: wire numbers tab
Set wire number placement | 493