2008

NOTE A wire connection point should only have up to 3 wire connections tied to
it. Adding more wires to a single point prevents the angled wire connection to tie
uniquely to the wire connection point.
Trim wires
Use this tool to remove a wire segment and dots as required. You can pick on
a single wire or draw a fence through multiple wires to trim.
1 Click the Trim Wire tool.
2 Select the wire segment to remove on the drawing or type F
followed by a [space] to remove multiple wires at once.
3 If you are removing multiple wires, draw a fence through the
wires to trim.
A Zoom Extents is triggered when a wire runs off the screen. If this zooming
back and forth becomes annoying during multiple trims then zoom back so
that all of the circuitry is completely shown on the screen, or press Z and
[space] at the trim prompt. This triggers a Zoom Extents that will persist
through the rest of the trimming edits.
NOTE You can use the AutoCAD Erase command to remove wires, but the wire
connection dots will not be automatically removed.
Trim wires | 439