2008

Insert 3-phase bus wiring
1 Click the arrow on the Insert Wires tool to access the Insert
Multiple Wires tool.
2 Click the Insert Multiple Wires tool.
3 Set the horizontal and vertical spacing for the wires.
4 Specify where to start the wires.
5 Set the number of wires to 3, and click OK.
During wire insertion, the current wire type displays at the
command prompt. The current wire type indicates the layer
name in which the new wires are drawn. You can override this
by typing "T" and selecting a new wire type from the Set/Edit
Wire Type dialog box. The new wire type becomes the current
wire type and the command continues with the wire insertion.
6 If starting at a component or bus, select the component. Drag
the cursor slowly to the right as the second and third phases
Insert 3-phase bus wiring | 435