2008

To rename the User1- User 20 column headers, right-click the project name
in the Project Manager and select Properties. In the Project Properties ➤ Wire
Numbers dialog box, Wire Type section, click Rename User Columns. In the
Rename User Columns dialog box, specify a new column name and click OK.
Renaming of user-defined columns is project-specific. You cannot rename the
Color, Size, or Layer Name columns. All of the data corresponding to the
header column can be copied, cut, and pasted to another column.
Pick
Allows you to pick a wire or line in the active drawing. Once you pick a wire,
the corresponding wire type record is highlighted. If you pick a line in the
active drawing, you can add the layer where the line resides to the list of valid
wire layers. A new wire type record is created automatically.
Change/Convert
Changes all the wires in the wire network to the se-
lected wire type record. If unselected, only a single
wire is changed to the selected wire type.
Change All Wire(s) in the Network
Changes the lines to the selected wire type in the
wire type grid.
Convert Line(s) to Wire(s)
OK
NOTE This is available only when one wire type record is selected in the list.
Makes the selected wire type the current wire type. If the selected wire type
does not already exist on the drawing, the wire layer is created on the fly and
the wire layer name and properties are saved in the drawing file. In order for
the layer to be created the following rules apply:
■ The layer name must be unique
■ The layer name cannot be left blank
■ The layer name cannot contain special characters such as / \ " : ; ? * | , = '
➤ <
Set wire type
158 | Chapter 3 Drawing and Project Properties