2008

Change wire types
You can change the wire type using the Change/Convert Wire Type tool or
by typing a "T" at the command prompt during wire insertion commands.
1 Click the arrow on the Insert Wire tool to access the
Change/Convert Wire Type tool.
2 Click the Change/Convert Wire Type tool.
Optionally, you can right-click on an existing wire and select
Change/Convert Wire Type.
3 In the Change/Convert Wire Type dialog box, select a wire
type record in the wire type list, or click Pick to select a wire
type record from the drawing.
If you right-clicked on a wire and selected Change/Convert
Wire Type, in the Change/Convert Wire Type dialog box, the
wire type corresponding to the selected wire layer is highlighted
in the list.
4 Make any selections in the dialog box.
If Change all wires in the wire network is selected, all wires in
the wire network are changed to the new wire type. If unselec-
ted, only the selected wire is changed.
If Convert Lines to Wires is selected, the selected lines are
changed to the new wire type. If unselected, the lines are ig-
nored.
5 Click OK.
6 Select the wires or lines in the drawing to change and press
Enter.
156 | Chapter 3 Drawing and Project Properties