2008

Destination component tag ID. You can use only one of the (%num-
ber) parameters.
%1
Equivalent of "%1:%P" (comp tag:term)%2
Equivalent of "%1:%P:%D" (comp tag:term:termdesc)%3
Equivalent of "%L%1" (IEC comp tag)%4
Equivalent of "%L%1:%P" (tag:term)%5
Equivalent of "%L%1:%P:%D" (tag:term:termdesc)%6
Equivalent of "%I%I%1" (INST prefix+IEC comp tag)%7
Equivalent of "%I%L%1:%P" (tag:term)%8
Equivalent of "%I%L%1:%P:%D" (tag:term:termdesc)%9
The part after the colon(:) is suppressed if the value is blank in %2 - %9
parameters (for example, %2=comp tag:term). The ":term" part is suppressed
if blank.
Save settings to the project file
The changes you make to the current drawing's configuration are saved on
the drawing’s invisible WD_M block. You can save a copy of these settings to
the project file. This makes the settings available as defaults for new drawings
that you might add later to the project. Alternately, you can retrieve selected
Save settings to the project file | 129