2008

8 Click the button with the wire coming in from the bottom.
9 Insert the terminal in the bottom center of the rectangle.
10 In the TERM02 attribute ➤ X?TERM02 wire connection point
dialog box, click OK.
11 In the Pin number default value dialog box, enter "GND" and
then click OK.
12 Click the button with the wire coming in from the right.
13 Insert the terminal in the center of the right-hand side of the
rectangle.
14 In the TERM03 attribute ➤ X?TERM03 wire connection point
dialog box, click OK.
15 In the Pin number default value dialog box, enter "L2" and
then click OK.
Your drawing should look like the following.
16 In the Terminal style/configuration dialog box, click Back to
Main Menu.
The Symbol Builder - Schematic Parent or Stand-alone symbol
dialog box redisplays. Notice that the number of connection
points that were placed is listed next to the Wire Connection
button.
Finishing the parent symbol
The additional options for creating a symbol listed below are not used for this
example, but you can use them when creating your own symbol if desired.
■ Terminal: Pace the TERMxx attribute if you didn't already place it. For ex-
ample, if you had selected "None" as the terminal style earlier, you could
Build your own symbols | 1229