2008

3 Click the button with the wire coming in from the left.
4 Insert the terminal in the center of the left-hand side of the
rectangle as shown.
TIP Always use an AutoCAD Snap to insert the wire connection
point.
Once you select the wire connection point, you can insert a
terminal attribute and assign a default pin number to the at-
tribute. The TERM01 attribute ➤ X?TERM01 wire connection
point dialog box displays. The terminal number TERMxx at-
tribute text can be linked to a wire connection point X?TERM
attribute. This is done by a match on the last two characters
of the TERMxx and the X?TERMxx attribute names.
NOTE The "xx" in TERMxx is an incrementing number based
upon how many terminal attributes have been added.
Use this dialog box to move the TERM01 text, change the text
height or justification, convert existing text entity to TERM-
DESC01 or TERM01 attribute, and indicate that there shouldn't
be a TERM text entity for the wire connection.
5 If the TERM01 text is not where you want it, click Move and
select the new location for the text.
TIP You may have to move the dialog out of the way to see where
the terminal insertion was originally placed.
6 Click OK.
7 In the Pin number default value dialog box, enter "L1" and
then click OK.
Build your own symbols | 1227