2008

The Drawing Audit tool displays a report of wire-related clean-up functions
that were performed.
Access:
Click the arrow on the Schematic Reports tool to access the Drawing Audit tool.
From the Projects menu, select Reports ➤ Drawing Audit.
Specifies to run the audit on the active drawing or selected
drawings in the active project.
Audit drawing or project
Redisplays the last audit report that was run. You can then
surf to the performed function, save the report, or print
the report for reference.
Previous
Goes to the error location within the drawing where the
error occurred and was fixed.
Surf
After you click OK, you can select the type of drawing audit to run. If you selected to audit the
project, select the drawings in the active project to audit, and click OK.
Looks for problems related to missing wires which were
connected via gap pointers. Also see Wires ➤ Wire Num-
bers Miscellaneous ➤ Check / Repair Gap Pointers.
Wire gap pointers
Looks for and cleans up wires pointing to nonexistent wire
numbers (this is the opposite of wire number floaters). Also
looks for bad color/gauge label pointers.
Bogus wire number and color/gauge
label pointers
Looks for and erases zero length line entities on the wire
layer.
Zero length wires
Looks for and erases wire numbers that are not linked to a
wire network (for example, the wire was manually erased
but wire number remains).
Wire number floaters
Draws a red outline around each wire entity. (Available
when running on the active drawing only.)
Show wires (mark in red)
Overview of real-time error checking | 1183