2008

Generate a report using format files
1 Click the arrow on the Schematic Reports tool to access the
Automatic Report Selection tool.
2 Click the Automatic Report Selection tool.
3 Select which report to generate from the schematic or panel
report list.
4 Specify the format file to use for the selected report. If there
aren't any format files to select from, you must click the Format
File Setup button to create and save a format file.
5 Click the Add button to add the report name and format file
to the Selected Reports list. This button is not active until both
a report name and format file are selected.
6 Continue adding more reports to the Selected Reports list.
For the File and Table Output options, an 'X' indicates that
the automatic generation will run that portion, while an 'O'
indicates that it will not run that portion.
7 Modify the output of a report type by selecting the report in
the Selected Reports list and then clicking the Modify Output
button. Make changes in the sub-dialog box and click OK.
8 Save the list of report names and format files for later retrieval
and usage.
9 Specify a starting drawing file location and filename, and the
drawing template file to use for the automatic creation of the
drawing files.
10 Click OK to generate a report for the selected type(s).
Automatic report selection
Run automatic reports | 993