2005

Table Of Contents

Attaching Destination Signal Arrows | 55

4 In the Signal - Source Code dialog box, specify:

Code: 24 VDC NEUTRAL

Click OK.

5 In the Source/Destination Signal Arrows dialog box, click No.

NOTE Click No to insert the signal arrows on the next drawing. Click OK to

insert the signal arrows on the current drawing.

6 Click the Next Project Drawing tool to access demo04.dwg.

7 Click the drop-down arrow on the Source Destination Signals tool to access

the Destination Signal Arrow tool.

Menu Wires ➤ Signal References ➤ Destination Signal Arrow

8 Respond to the prompt as follows:

Select wire end for Destination:

Select the top of the neutral wire at line reference 402 (4)